I need to replace my generator ?

[Guest]

History Commands

[July 26, 2010, 01:36:19 PM] Jon74panel: I'm burning 2 quarts of oil every time I fill up, I dread going up hills because its just a cloud of smoke behind me, help!

[July 26, 2010, 01:37:35 PM] Jon74panel: does this say drive no futher? I am 1900km away from home, do I limp it home?

[July 26, 2010, 01:38:18 PM] Jon74panel: Location:tofino,BC Destination:Calgary,AB

[July 26, 2010, 01:44:07 PM] Jon74panel: there is a small pool oil on the fan. *scared

[July 27, 2010, 02:49:48 AM] Beetle: http://www.type2.com/ & click on 'AIRS' icon.

[July 27, 2010, 07:45:05 AM] Orange_crush: help! acceleration problem.  bus can only go 5mph on hills..picks up fine on flats and dwon hill.  single carb. 2000cc  motor

[July 27, 2010, 09:04:10 AM] addicted: hey any one on?

[July 27, 2010, 09:04:44 AM] addicted: got a question abdout my piont set heating up

[July 27, 2010, 09:29:38 AM] addicted: poof of smoke from the pionts and gf claims from the dash aswell

[July 27, 2010, 09:38:17 AM] Beetle: Addicted: Post in the forum for better results.

[July 27, 2010, 10:56:36 AM] blue bus: does anyone know how to take the handle off the slider door ao a 74 transporter

[Today at 09:29:31 AM] scoobz: need help adjusting electric choke on 72 type 2

[mexibus]

I have to replace the generator on my Bay, my question is do I need to take off the intake to be able to get the fan out or will loosening the shroud and lifting it be enough to get the fan out ? if this make any sence ?

[Fastmc25]

I usually  remove the 36mm nut from the fan... wiggle the fan loose from the hub........ take the 4 screws out of the shroud holding the gen in place.... remove the belt and clamp band from the gen stand..... and carefully slide the gen out.............. using care not to loose the shims .....

replacement is reverse order.............. just be sure to torque the nut on the fan to 35 - 40ft. lbs.

Need to get a Bentley Manual........ it'll really help answer many of your questions....